Brunton Multi-Navigator Spezifikationen PDF herunterladen (Seite 74)

The

Oregon

and

Colardo

can be used for moving map

Set the GPS Interface to "Garmin Spanner" (do not install or start the Garmin Spanner

software, it is not needed)

connect to the PC using normal USB cable

on the GPS screen set mass Storage Mode OFF

in OziExplorer configuration make sure "Garmin USB" and "Use PVT for Garmin instead of

NMEA" are both checked

start moving map in OziExplorer

Special Notes

Symbols

There are various Symbol sets for the Garmins, some have been predefined in the Symbol Set combo

box. If there is no defined symbol set for your GPS then use the

Create

button on the GPS tab in

OziExplorer Configuration to specify the set of symbols your particular Garmin model supports, or

use the Garmin symbol set. This gives access to all the Garmin symbols, however those which your

GPS does not support cannot be uploaded and will be ignored. Any symbols which aren't applicable

to a particular model are ignored and replaced with the dot symbol.

Tracks

Some model Garmins only have 1 track and this is downloaded without problems.

Some model Garmins such as the GPS III which can store multiple tracks in the GPS, results in all of

the tracks being download as a single track.

Current Garmin models download the Active Track and the saved tracks as separate tracks, after

downloading these will be shown in the Track Control as separate tracks. These tracks must be saved

separately by highlighting the track in the track list and selecting the save button on the Track

Control toolbar.

Ozi

Explorer

Magellan GPS Support

This page covers the various ways a Magellan GPS can connect to a PC and how to configure the

GPS and OziExplorer.

Links to Sections

Which Port is My GPS Using

Configuring OziExplorer to use a Magellan GPS Connecting by a Serial port

Page

252

OziExplorer Help Contents

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 251 252

Keine Kommentare

Brunton Multi-Navigator Spezifikationen Seite 74