Brunton Atlas MNS Spezifikationen PDF herunterladen (Seite 20)

ware.

You can also run one of our free Brunton GPS emulators on your laptop,

and operate it with real-time position information.

To use it, plug the power adapter into a cigarette lighter socket, plug the

DB-9 connector into a serial port on the computer and attach the cable to

the Atlas. Then see "Com Port Configuration" in Sec. 5.

MMC or SD Memory Card Installation

Your Atlas uses a MultiMedia Card to store information, such as custom

maps, waypoints and other GPS data. The unit can also use Secure Digital

Cards (SD cards) to store information.

NOTE:

Throughout this manual, we will use the term MMC, but just remember

that your unit can use an MMC or SD card to store data.

Both of these solid-state flash memory devices are about the size of a

postage stamp. An SD card is slightly thicker than an MMC. As this manual

went to press, MMCs were available in storage capacities of 8 MB, 16 MB,

32 MB, 64 MB and 128 MB. SD cards were available in capacities of 8 MB,

16 MB, 32 MB, 64 MB, 128 MB, 256 MB and up. We have successfully

tested SD cards up to 512 MB.

Additional MMC cards are available from Brunton; see ordering information

inside the back cover of this manual. MMCs and SD cards are also avail-

able at many consumer electronics stores.

The MMC slot is located in the battery compartment, beneath the batteries

on the right side of the unit. The contact pins are springy, to make it easier

to insert and remove the MMC card.

To remove an MMC

1. Remove battery compartment cover.

2. Remove batteries, if present.

3. Hold unit facedown in right hand. Use your thumb or index finger and

press down on the center of the MMC label.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 127 128

Keine Kommentare

Brunton Atlas MNS Spezifikationen Seite 20