Brunton Atlas MNS Spezifikationen PDF herunterladen (Seite 81)

GPS Setup Menu, left, GPS Simulator Menu, right.

Make the desired settings, then turn the simulator on by highlighting the SIMU-

LATOR

ON box and pressing ENT key. Press EXIT to erase this menu. A mes-

sage appears periodically, reminding you that the simulator is on. To turn the

simulator off, repeat the above steps or turn the unit off.

While in simulator mode, you can press

EXIT to clear the steering and

speed boxes from the screen while continuing the simulation. This will al-

low you to use the map cursor during a simulation. To turn steering and

speed boxes back on again, return to the GPS Simulator menu, select the

STEER WITH ARROWS command, and press ENT, then press EXIT|EXIT|EXIT to

return to the previous page.

Simulating Trail or Route Navigation

In Simulator mode, your unit can automatically follow a trail or route with-

out manual steering if you use these steps:

1. From the Map Page, go to the simulator menu. Pick a

STARTING POSITION

at or near the beginning of your trail/route. Enter an approximate

TRACK

(shown in compass degrees) that will point you toward the start of the

trail/route.

2. Set

SPEED to zero. Select STEER WITH ARROWS command and press ENT,

which turns on the simulator and returns you to the Map Page.

3. Begin navigating along the trail/route. (If you are close enough to the

first waypoint, the arrival alarm will usually go off as soon as navigation

begins. Press

EXIT to clear the alarm.) When navigation starts, press ↑

(since you're using the Simulator's

STEER WITH ARROWS command) to in-

crease speed to the desired setting.

4. Press

EXIT to turn off the steering and speed boxes. The unit will now

automatically "steer" along the trail or route. When you arrive at your "des-

tination," cancel navigation as you normally do.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 127 128

Keine Kommentare

Brunton Atlas MNS Spezifikationen Seite 81